3D Printed Revolver

Game Warden
TPWD to Hold Three Drawings for Lifetime Licenses
August 25, 2016
3rd Annual Texas Airgun Show
September 7, 2016

This 3D printed revolver is a step up from the single shot Liberator we saw a few years back.

Although the argument for gun control should have ended in 1791 with the ratification of the Bill of Rights with the simple phrase “shall not be infringed”, progressives tirelessly attempt to erode our God given and constitutionally guaranteed right of the people to keep and bear arms.  This makes”DIY” firearms amusing because it proves that gun control will never work.  Heck, you can build a fully functional AK47 receiver out of a shovel if you really want to.  Is the ATF going to raid Lowes?

A few years back The Liberator 3D printed single shot pistol made national news, and then I recently ran across this 3D printed revolver that looks quite interesting as well.

The gunsmith printer calls this project the “PM522 Washbear” and claims it is his “under the bed gun”. It is legally registered as required by law in Michigan, and also contains enough steel inserted into the handle to comply with the undetectable firearms act.  I find the trigger pull of 20+ pounds a bit ridiculous, but the creator calls this a “safety feature”.  Evidence of test firing is shown on the firearm, but no target groups or ballistic information such as velocity of the fired rounds were given.

Would you be interested in a 3D firearm?  The cost would probably be attractive.

Find the original post here.

3D Printed 8 Shot Revolver

3D Printed 8 Shot Revolver

Loading

Comments are closed.