Myth-Busting: 1″ per Yard Shotgun Pattern Spreads

Man attacked by gator in Houston lake
July 7, 2014
UPDATE: Facebook deletes Texas cheerleader’s hunting photos after outcry
July 7, 2014


We can’t even begin to count the amount of times we’ve read, been told or heard someone say that shotgun patterns spread about 1″ per yard after exiting the barrel.  The old adage predicts, if a shooter is 10-yards from his target, the pattern will be 10″ and 15″ at 15-yards and so on.  Typically, this discussion is framed around defensive use of the shotgun with a relatively short 18-20″ barrel and some sort of defensive load like the ubiquitous 00 buck.

Having this not match our experience,  we decided to head to the range and see what typical spreads we would encounter.  For this exercise, we used a series of 5-barrels listed below and Winchester Super-X 105-203-098, non-plated buckshot provided by Brownells.  We selected this full power, 1325 fps, 2 3/4″ load because we have found that the tactical and reduced recoil loads on the market pattern tighter then non premium buck and thought this load would provide a better representation of what the typical defensive shotgun owner would encounter.


Test barrels were all 18″ in length and described below:

  1. back bored & lengthened forcing cone barrel (back bored until reamer was flush with muzzle)
  2. Vang Comp Custom Barrel
  3. Remington Factory Improved Cylinder
  4. Remington Factory Cylinder
  5. back bored and forcing cone lengthened 2″ from muzzle


We measured the extreme spread of each pattern and recorded the results below in inches:

Barrel 7 yards 15 yards 20 yards Avg spread per yard
Back Bored 2 5 ¼ 7 .35”
Vang Comp 1 ¾ 7 7 ¼ .36”
Remington IC 5 10 7/8 11 ½ .58”
Remington Cyl 3 ¼ 9 1/8 12 .60”
Back bored 2” from muzzle 4 ¼ 15 ¾ 19 ¼ .96”


The 20-yard pattern size was divided by 20 to estimate the average spread per yard of the pattern in inches.  Results for this calculation ranged from .35″ to .96″. Barrels at each end of this range represented modifications to stock configurations one would normally encounter in the defensive shotgun market.  The results for the two unmodified barrels, the Remington Improved Cylinder and Cylinder, showed an average spread of .58″ and .60″ respectively.

While the barrel we had back bored 2″ short from the muzzle fit the 1″ per yard tale, it should be noted that we intentionally back bored it short as part of our testing protocol from another article.  When examining stock barrels, the spread was approximately half of the anecdotal 1″ per yard spread.

So what does all this mean?

Pattern your gun.  Next time you wonder how your defensive shotgun patterns, take it out and shoot it with your favorite load at different distances.  Normally, we shoot 7, 15 and 20-yards for T and E, but we do shoot buck at shorter and longer ranges on occasion.  If you haven’t done so, do it; and next time you hear someone tell the 1″ per yard myth, make sure you set them straight.

Comments are closed.